ROLLER SHUTTERS

The installation procedure takes between an hour or two each window depending on the size, scaffolding requirements and accessories included. If you decide to proceed with us after the measure and quote, we can begin the manufacturing process. Unlike some other competitors, we make our roller shutters in South Australia, which means they're produced with the finest quality materials and are engineered to survive Australian weather.

We'll call you to schedule a time to come out and instal your custom roller shutters when they've been manufactured.

Your roller shutters are a wonderful addition to your home, but they may need to be cleaned every now and then. You may need to clean the roller shutter surfaces to remove spider webs, watermarks, and dust.

To be able to clean your shutters you will need:

• Soft cloth
• Sponge
• Small water bucket with warm water
• Washing up liquid
• Soft brush
• Soft cloth
• Garden hose

Step 1. Cleaning the outside of your roller shutters

• Make sure your roller shutters are all the way down, then walk outside and mix some washing up liquid with some warm water in the water bucket.
• Wipe down the roller shutter with a clean sponge to eliminate any dirt or dust particles.
• It's possible that little particles become lodged between the roller shutter's slats.
• Wash away any cleaning solution using a garden hose.
• To assist with the cleaning procedure, you may use a hose and raise the pressure on the hose by nipping the end with your thumb and finger.
• High-pressure washers should not be used on the slats of roller shutters because they may cause damage. Also, make sure you don't hose inside the box, since this might damage the motor's circuitry.
• It's a good idea to dry your roller shutters with a cloth afterwards to eliminate watermarks.
• Make sure the fabric is completely dry before drying the shutter using an up-and-down motion.
• After the shutters have dried, roll them up approximately halfway and begin working on the inside of the shutters.

Step 2. Cleaning the inside of the roller shutter.

• Cleaning behind the roller shutter might be difficult depending on the form and size of the window. If you're having difficulties getting behind the hard-to-reach locations from the inside, a sponge on a stick will assist. These may be found at Bunnings and other home improvement retailers.
• You may either clean the shutter from the inside or halfway down. This is suitable for the shutter's lower half. Then complete the upper half of the interior of the shutter from the inside of the house.
• Cleaning from the outside in helps you to get rid of the worst of the filth or clutter without allowing it to enter the house.
• Unless they've been down for weeks and spiders have taken up residence, the debris inside is usually modest. Some of the home's brickwork may also need to be cleaned.
• When the shutters are halfway down, it's best not to use too much pressure when cleaning from the inside out.
• Remove spider webs with a stick and wind it around to rapidly rid of it with least hassle; be cautious of any spiders that crawl out.
• Apply the same technique to the interior of the shutter as you did to the outside. Clean in an up and down motion with a wet sponge and dishwashing liquid.
• Ensure that all of the soap has been gone before wiping off the area with a dry cloth.
• Once that's done, double-check that the roller shutters work as they should and repeat the process for the rest of your home's roller shutters.

A perfectly fitted roller shutter has been shown to minimise incoming noise by as much as 80%.

Roller shutters can relieve your stress levels in addition to providing privacy and light control. With the added benefit of noise reduction. You may enjoy the peace and quiet with roller shutters.

The structure of your home must be properly sealed to guarantee that it is effective. The efficiency of roller shutter noise reduction can be seriously impacted by air gaps. This is why it's critical to have your shutters fitted by a reliable and experienced professional. At Dynamic Home Enhancements, we guarantee that our experts will do a fantastic job installing your shutters. That's why we're Adelaide's go-to company for external window treatments.

Another significant advantage of roller shutters is the insulation they give for your home. A quality polyurethane insulation is pumped into each section. During the winter, this will keep your home toasty warm, and during the summer, it will keep your home cool.

Our shutters are made of 9mm thick slats, however some of our rivals only utilise 5.7mm.

Premium roller shutters from DHE Group are filled with a specific insulative substance that gives homeowners more control over the temperature inside their home. This means customers may enjoy a more pleasant atmosphere while also lowering their energy expenditures.